VTE Europe
Units: SAE (Inch) Metric (MM)
< Back

Bulkhead Connector

Brochure

Our bulkhead connector, specifically developed for the marine industry, supports a stable connection between engine battery system, and a house battery system. Designed to be installed by a single person, the process can be completed in a short amount of time.

ATTENTION: For Use In Non-Ignition Protected Environment Only!

Bulkhead connector w/ pressure ring

72101 Series

IMPORTANT: Conductive VS. Retaining Nuts


* Connect engine battery system to house battery system
Under Cabin Side

Engine Side

* Device can be installed by a single person
* Can support up to 3 cables on each connection
* High strength polypropylene faceplates
* Designed for foil-covered sound insulation on engine side
* Bulkhead thickness from 12.7 mm to 50.8 mm
* Insulation thickness from 12.7 mm to 50.8 mm
* Brass connection posts
* Meets NEMA rating 3S, IP54 equivelant
* Max Amperage: 500 amps @ 12 vdc
Max Voltage: 48 vdc
* 15 C temperature rise at 500 amp
* Optional terminal insulators: 232 Series, 375 L, 375 T
* When used with terminals insulators, meets: ISO 10133, USCG 33 CFR Subpart I, SAE J2120 8.5 & ABYC E-9.4 H
* View Installation Guidelines

Part Number Panel
Thickness
Barrier Material
7220100 0 - 6.35 mm Bulkhead Only
7210100 25.4 mm - 38.1 mm Bulkhead and Insulation
7210110 38.1 mm - 50.8 mm Bulkhead and Insulation
7210101 50.8 mm - 63.5 mm Bulkhead and Insulation
7210111 63.5 mm - 76.2 mm Bulkhead and Insulation
7210102 76.2 mm - 88.9 mm Bulkhead and Insulation
7210112 88.9 mm - 101.6 mm Bulkhead and Insulation

For quantities under 25 please go to VTE Warehouse